Add a project

Add projects for OpenLab CDS, OpenLab CDS EZChrom edition, OpenLab Data Analysis, or OpenLab CDS ChemStation Edition (if generic projects are enabled for your system). If you are using OpenLab ECM Intelligence Reporter, see Add a reporting project. To create a copy of an existing project, see Duplicate a project.

1. Click Projects and select  or any project group.

2. Click Create > Create Project.
   
   
   

3. In the Name text box, type a name for the project.

4. Select Include project groups in project path to include the project group name in the Project folder path.

5. In the Project folder path text box, you can leave the default folder path, enter the path to the folder, or click Browse and navigate to and select the folder. The maximum file path length is 256 characters. If the root folder was specified during a Standalone Workstation installation, it cannot be changed.  
   If you want to use an existing ECM storage location for a new project see Add a new project to an existing ECM location.

6. In the Description text box, type a description of the project.

7. Select an Application to create an application-specific project. You can select more than one application. If no application is selected, a generic project will be created.

8. If applicable, click the Settings tab for your application. The tabs shown are based on your Application selection.

1. Expand File Locations.
   
   The file paths are automatically generated based on the Project folder path specified in Step 4. You can change the name and path of all file locations; however, the paths for Methods, Sequences, and Results must be within the root project folder.
   
   

2. Expand Project Options.

3. Select Allow printing of unsaved method and results to print reports without saving data or results after reprocessing.

4. Select Enforce method approval to prevent users from using Generic or Obsolete methods unless they have the appropriate privileges. Only Approved methods can be used by users without specialized privileges. See Use method status for more information.

5. If Process calibration at the end of each cycle is not selected, calibration standards acquired within this project are processed and printed at the end of their acquisition. Amounts and concentrations for calibration standards are computed with interim curves.
   
   If this option is selected, result processing and report printing for a set of calibration standards is delayed until all calibration runs of this set are completed. there are no interim calibration curves.
   
   

6. (Optional) Add custom parameters to your project.

7. Expand Audit Trail Settings.
   
   On the Method, Sequence, and Results tabs, select Automatically enable audit trail.
   
   

   • The Method Audit Trail is available in Data Analysis and in the Acquisition Method window in Acquisition.
   • The Sequence Audit Trail is available in the Sequence table in Acquisition.
   • The Results Audit Trail is available in the Data Processing pane in Data Analysis.

8. On the Results tab, select Prompt for reason when saving results and aborting run queue items to prompt users to enter a reason for aborting a run in Acquisition.

9. Click OK.