The values resulting from system suitability calculations are shown in Data Analysis in the injection results, and can be used in a report template. The names in the injection results may differ from the data field name.
| Name in injection results | Data field name in the report template editor |
|---|---|
| Dead volume1 | Injection_ColumnDeadVolume |
| Injection_ColumnDeadVolumeUnit |
|
|
Diameter1 |
Injection_ColumnDiameter |
| not shown |
Injection_ColumnLength |
| not shown |
Injection_ColumnLengthUnit |
|
Name1 |
Injection_ColumnName |
| Particle size1 | Injection_ColumnParticleSize |
| Injection_ColumnParticleSizeUnit |
|
| Void time1 |
Injection_ColumnVoidTime |
| Serial number1 | Injection_ColumnSerialNo |
| not shown |
Injection_RefInjectionInfo |
| not shown |
Noise periods (available in a snippet) |
| Asymmetry 10% | Peak_Asymmetry_10Perc |
| Capacity factor | Peak_CapacityFactor |
| not shown | PeakModelRT (available as a custom field at Peak level) In a report template, use the expression =CFE(Peak_CustomFields,"PeakModelRT") to show the value. In the Custom Calculation Editor, use the expression CurrentPeakOrGroup.GetCustomField("PeakModelRT") to show the value. |
|
Noise | Peak_Noise |
| p/v ratio | Peak_PeakValleyRatio |
| Plates pm EP | Peak_PlatesPerMeter_EP |
| Plates pm JP | Peak_PlatesPerMeter_JP |
| Plates pm USP | Peak_PlatesPerMeter_USP |
| Relative retention time EP | Peak_RelativeRetTime_EP |
| Resolution EP | Peak_Resolution_EP |
| Resolution JP | Peak_Resolution_JP |
| Resolution USP | Peak_Resolution_USP |
|
Selectivity |
Peak_Selectivity |
| Signal to Noise |
Peak_SignalToNoise |
| Tailing |
Peak_TailFactor |
| Plates EP |
Peak_TheoreticalPlates_EP |
| Plates JP |
Peak_TheoreticalPlates_JP |
| Plates USP |
Peak_TheoreticalPlates_USP |
| Width 5% |
Peak_Width_5Perc |
| Width 10% |
Peak_Width_10Perc |
| Width 50% |
Peak_Width_50Perc |
| Width 5 sigma |
Peak_Width5Sigma |
| Width tangent |
Peak_WidthTangent |
|
1 |
In the Data Processing view, this value is only shown in the processing method. It is not listed in the Injection Results. |