Plumbing (Valve Thermostat Cluster Column Assignment)

The Plumbing section of the Column Assignment dialog box contains a table where you can specify the plumbing assignment for each valve position.

The table has four columns:

Path	The number of the path; the number of available paths depends on the topology of the Valve Thermostat Cluster.
Usage	The usage of the path. This can be a column, a connection to Waste, a connection to Bypass, or None. Click the down-arrow and select the usage from the drop-down list.
Column Host	The column device to which the path is connected. The available column devices depend on the configuration of the Valve Thermostat Cluster. Click the down-arrow and select the column device from the drop-down list.
Location	The location of the column in the column host. Columns can be either half-length or full-length (full-length columns take up two positions). Click the down-arrow and select the location from the drop-down list. Depending on the configured column hosts, you can choose from: Left 1 .. Left n (left side positions for half-length columns) Right 1 .. Right n (right side positions for half-length columns) Full 1 .. n (full-length columns occupying both sides) Upper (G7130A Integrated Column Compartment only) Lower (G7130A Integrated Column Compartment only) Waste Bypass None (no connection, or connection to an external column)

When you select a line in the table, the corresponding line is highlighted in the Column Tag Information table.