Click the down arrow and select the pressure units from the drop-down list. You can select from bar, psi or MPa.
This check box is marked to indicate that a BCD/external contacts board has been detected during autoconfiguration. For manual configuration, mark the External contacts board installed check box to indicate that a BCD/external contacts board is installed. Specify the use of external contacts in the External Contacts section of the method setup.
This check box is not available for the G7120A or G7132A, where the seal wash is carried out automatically. |
This check box is marked to indicate that an optional seal wash kit has been detected during autoconfiguration. For manual configuration, mark the Seal wash installed check box to indicate that a seal wash kit is installed. Specify the seal wash parameters in the Seal Wash section of the pump control parameters.
This check box is marked to indicate that a solvent selection valve has been detected during autoconfiguration. For manual configuration, mark the Solvent selection valve installed check box to indicate that a solvent selection valve is installed. Specify the solvent parameters in the Solvents section of the method setup.
The installed mixer is detected during autoconfiguration. For manual configuration, click the down-arrow and select the installed mixer from the list. If you select a Custom Mixer, specify the custom mixer type in the Custom Mixer field.
This check box is marked to indicate that ISET is installed. Click to open the ISET Configuration dialog box, which allows you to configure a sampler for the ISET emulation.