Click the down arrow and select the pressure units from the drop-down list. You can select from bar, psi or MPa.
This check box is marked to indicate that a BCD/external contacts board has been detected during autoconfiguration. For manual configuration, mark the External contacts board installed check box to indicate that a BCD/external contacts board is installed. Specify the use of external contacts in the External Contacts section of the method setup.
When the External contacts board installed check box is cleared, the External Contacts section of the method setup is not present. |
This check box is marked to indicate that an optional seal wash kit has been detected during autoconfiguration. For manual configuration, mark the Seal wash installed check box to indicate that a seal wash kit is installed. Specify the seal wash parameters in the Seal Wash section of the pump control parameters.
This check box is marked to indicate that a solvent selection valve has been detected during autoconfiguration. For manual configuration, mark the Solvent selection valve installed check box to indicate that a solvent selection valve is installed. Specify the solvent parameters in the Solvent section of the method setup.