Click the down arrow and select the pressure units from the drop-down list. You can select from bar, psi or MPa.
Shows the pump head that is installed in the pump.
For the G7161B, click the down-arrow and select the pump head from the drop-down list.
This check box is marked to indicate that a second pressure sensor has been detected during autoconfiguration. For manual configuration, mark the 2nd pressure sensor installed check box to indicate that a second pressure sensor is installed in the pump.
This check box is marked to indicate that a BCD/external contacts board has been detected during autoconfiguration. For manual configuration, mark the External contacts board installed check box to indicate that a BCD/external contacts board is installed. Specify the use of external contacts in the External Contacts section of the method setup.
When the External contacts board installed check box is cleared, the External Contacts section of the method setup is not present. |
This check box is not available for the G7161A/B, where the seal wash is carried out automatically. |
This check box is marked to indicate that an optional seal wash kit has been detected during autoconfiguration. For manual configuration, mark the Seal wash installed check box to indicate that a seal wash kit is installed. Specify the seal wash parameters in the Seal Wash section of the pump control parameters.