Eject (High Performance Autosampler)

Moves to a specified position and ejects a specified amount from the needle.

Parameter	Value	Description
Eject	Default	The default amount specified in the Set Up Agilent Autosampler panel. See Set Up High Performance Autosampler
	Maximum	The maximum amount defined by the injector configuration.
	<value> (µL)	A specified amount that overrides the default amount.
to	Sample	The position specified in the sample information or sequence/worklist.
	Location	From a specified location.The location can be a well or a vial. See Specifying a Location.
	Seat	The seat capillary. (Not available if a Flexible Cube is installed).
	Waste	The waste vial.
	Sample+
	Vial+	This function is for vial trays only.
Speed	Default	The default eject speed specified in the Set Up Agilent Autosampler panel. See Set Up High Performance Autosampler
	Maximum	The maximum eject speed.
	<value> (µL/min)	A value that overrides the default eject speed.
useOffset	Default	The default offsetposition, specified in the Set Up Agilent Autosampler panel. See Set Up High Performance Autosampler
	<value> (mm)	-2.5 to +35 mm below or above the normal offset position

The parameters shown are dependent on the selected source.