The Multi-wash table allows you to specify up to four steps that will be used to clean the system. The Start Cond. step is obligatory; you cannot switch it off. However, you can switch off the Needle Outer wash if it is not required.
For each cleaning step,
Click the Solvent down arrow and select the solvent to use (S1, S2, S3) or switch the step Off.
Specify a duration (in seconds) in the Time [s] field.
Mark the check boxes for Needle Inner (the inside of the needle),Needle Outer (the outside of the needle) and/or Draw Port to include these actions. If all three are selected, they are carried out simultaneously; if none is selected, the step is ignored (equivalent to selecting Off).
Add a comment in the Comment column, if necessary. The Comment is limited to 20 characters; however, the use of some special characters may reduce this limit.