Eject (Online Sample Manager/Hybrid Multisampler)

Moves to a specified position and ejects a specified amount from the needle.

Parameter

Value

Description

Eject

Default

The default amount specified in the current method.

See Set Up Online Sample Manager/Hybrid Multisampler.

Maximum

The maximum amount defined by the multisampler configuration.

<Value>

A value that overrides the injection volume specified in the current method.

to

Sample

The default position as specified in the sample information or sequence/worklist.

Location

A specified location on one of the sample containers that are loaded in the hotel. The location can be a well or a vial.

See Specifying a Location.

Current Container

A user-specified location that refers to the currently used sample container, allowing you to omit the multisampler drawer to be used from the specification. In this case, it is sufficient to specify the row and column of the location to be used.

Sample+

A user-specified increment to the previously specified vial location (as specified in the sample information or sequence/worklist) by N positions; sample is ejected into the new position.

Sample+ is intended for trays that support linear addressing only. Be aware that wellplate positions will also be incremented linearly (For example, A1, A2, A3...), but reaching the end of a wellplate row will cause a sample location error. Use Location+ for wellplates.

Location+

A user-specified increment to the previously specified wellplate location (as specified in the sample information or sequence/worklist) by N rows and M columns; sample is ejected into the new position.

Location+ is intended for trays that support row and column addressing only. Be aware that, if this function is used with trays that support linear addressing, any row increment will be ignored.

Plate+

A user-specified increment to the previously specified plate position (as specified in the sample information or sequence/worklist) by N positions; sample is ejected into the new plate.

Waste

The waste container.

Speed

Default

The default eject speed as specified in the current method.

See Set Up Online Sample Manager/Hybrid Multisampler.

Maximum

The maximum eject speed.

<Value>

A value that overrides the eject speed specified in the current method.

Use Offset

Default

The default offset position as specified in the current method.

See Set Up Online Sample Manager/Hybrid Multisampler.

<Value>

A value that overrides the Needle Height Position Offset specified in the current method.