Autosampler Dashboard Panel

Module Graphic

The items in the autosampler graphic have the following meaning and function:

	Displayed during an injector program, either internal or from the injector program/pretreatment table. The highlight moves during the injection. At the end of the run, the icon is removed.
	The syringe graphic is animated during the injection.
	Denotes an injection from a vial. The current sample location is shown to the right of the graphic. The tooltip displays the current tray configuration.

Actuals

The following standard autosampler actuals are displayed:

Injection Volume	The volume of the last injection (in µL).
Sample Location	The location of the last sample.

Context Menu

The context menu contains the following commands:

Control	Displays the sampler's Control dialog box.
Method	Displays the sampler's Method Setup dialog box.
Injector Program	Displays the sampler's Injector Program.
Error Method	Set Error Method Sets the error method to the method that is currently available in the hardware. The error methods are loaded automatically on all modules if an error occurs. Clear Error Method Removes the currently loaded error method.
Identify Device	Causes the LED on the front of the module to blink for a few seconds.
Home Arm	Moves the gripper arm to its home position to allow you to remove the tray.
Reset Sampler	Sends a reset signal to your autosampler. During the reset, the injector is in a Not Ready state (yellow).
Release Vial	Moves the gripper arm to the front, outside the vial tray and releases the vial from the gripper arm.
Switch Valve to Bypass	Switches the valve from the main flow path to bypass.
Switch Valve to Mainpass	Switches the valve from bypass to the main flow path.
Park	(G4290B only) Choose the Park action from the submenu: Park Arm Moves the gripper arm to a transport position. In this position, the gripper arm is fixed to avoid unexpected movement of the arm during transport. Home Arm Moves the gripper arm to its home position to allow you to remove the tray.