Prep Pump Dashboard Panel

Module Graphic

The items in the pump graphic have the following meaning and function:

	(G1361A only) Indicates that an External Contacts board is installed.
	When the solvent level falls below the specified volume, the yellow warning is shown; when the bottle is empty, the red error is shown. Clicking on the solvent bottle displays the Bottle Fillings dialog box. The tooltip for the bottle shows the solvent name.
	(G7161B only) Indicates the presence of a solvent selection valve. Use the context menu to switch the valve.
	The pressure setpoints. The red line shows the current maximum pressure limit; the gray area shows the current pressure (also shown as text).
	(G7161B with second pressure sensor only) The pressure setpoints. The red lines show the current maximum pressure limits; the gray areas show the current pressures (also shown as text above and below the graphic).

The current solvent flow rate (in mL/min) is displayed above the pressure display.

Actuals

The following pump actuals are displayed:

Flow	The current solvent flow rate (in mL/min).
Pressure	The current pump pressure (in bar or psi).
Pressure A, B	(G7161B with second pressure sensor only) The current pressure readings of each of the two pressure sensors.
Ripple	(G1361A and G7161B) The current ripple (in %).
Ripple A, B	(G7161B with second pressure sensor only) The current ripple readings (in %) of each of the two pressure sensors.
Pressure Limit	The current maximum pressure limit. The reason for any limitation to the maximum pressure limit is displayed (G7161A/B only)
Flow Limit	The current maximum flow limit. The reason for any limitation to the maximum flow limit is displayed (G7161A/B only)
Composition A, B	(G7161A/B only) The percentage contribution of each of the solvent channels to the current solvent composition.
Purge Status	(G1361A only) The current status of the purge, on or off.
Purge Time	(G1361A only) The current purge time (in minutes).

Context Menu

The context menu contains the following commands:

Control	Displays the pump's Control dialog box.
Method	Displays the pump's Method Setup dialog box.
Error Method	Set Error Method Sets the error method to the method that is currently available in the hardware. The error methods are loaded automatically on all modules if an error occurs. Clear Error Method Removes the currently loaded error method.
Identify Device	Causes the LED on the front of the module to blink for a few seconds.
Switch On/Off	Toggles the status of the pump, on or off.
Switch Solvent Selection Valve A/B	(G7161B only) Switches the solvent selection valve to the alternative position.
Bottle Fillings	Displays the Bottle Fillings dialog box.
Purge on/off	(G1361A only) Toggles the status of the purge, on or off.
Seal Wash Prime	(G7161A/B only) Allows you to ensure that all air bubbles in the seal wash lines are removed (for example, after the seal wash solvent bottle has been refilled).
Modify	Manual Flow Limit Displays the Manual Flow Limit dialog box, which allows you to set an upper limit on the flow rate.