Data fields used for system suitability

The values resulting from system suitability calculations are shown in Data Analysis in the injection results, and can be used in a report template. The names in the injection results may differ from the data field name.

Name in injection results	Data field name in the report template editor
Dead volume¹	Injection_ColumnDeadVolume
	Injection_ColumnDeadVolumeUnit
Diameter¹	Injection_ColumnDiameter
not shown	Injection_ColumnLength
not shown	Injection_ColumnLengthUnit
Name¹	Injection_ColumnName
Particle size¹	Injection_ColumnParticleSize
	Injection_ColumnParticleSizeUnit
Void time¹	Injection_ColumnVoidTime
Serial number¹	Injection_ColumnSerialNo
not shown	Injection_RefInjectionInfo
not shown	Noise periods (available in a snippet)
Asymmetry 10%	Peak_Asymmetry_10Perc
Capacity factor	Peak_CapacityFactor
not shown	PeakModelRT (available as a custom field at Peak level) In the Custom Calculation Editor, use the expression CurrentPeakOrGroup.GetCustomField("PeakModelRT") to show the value. In a report template, use the expression =CFE(Peak_CustomFields,"PeakModelRT") to show the value.
Noise	Peak_Noise
p/v ratio	Peak_PeakValleyRatio
Plates pm EP	Peak_PlatesPerMeter_EP
Plates pm JP	Peak_PlatesPerMeter_JP
Plates pm USP	Peak_PlatesPerMeter_USP
Relative retention time EP	Peak_RelativeRetTime_EP
Resolution EP	Peak_Resolution_EP
Resolution JP	Peak_Resolution_JP
Resolution USP	Peak_Resolution_USP
Selectivity	Peak_Selectivity
Signal to Noise	Peak_SignalToNoise
Tailing	Peak_TailFactor
Plates EP	Peak_TheoreticalPlates_EP
Plates JP	Peak_TheoreticalPlates_JP
Plates USP	Peak_TheoreticalPlates_USP
Width 5%	Peak_Width_5Perc
Width 10%	Peak_Width_10Perc
Width 50%	Peak_Width_50Perc
Width 5 sigma	Peak_Width5Sigma
Width tangent	Peak_WidthTangent
¹	In the Data Processing view, this value is only shown in the processing method. It is not listed in the Injection Results.