After you have launched an instrument you can start a method run in the DWM software.
Select an existing method or create a new one.
Click Status.
The Method Run panel is displayed.
Enter a result name in the Method Run section.
Select whether to use the DDM or to manually introduce the dosage form by clicking the appropriate button.
Select whether to Instant Start or to Wait for the vessel temperature to be within the specified tolerance set for the method.
For this step, the manifold will be lowered into the media to monitor the temperature.
Select the number of active vessels. This will update the instrument status panel.
Once all parameters have been defined click Start Run.
The method run starts. All data of the run are saved and available later for the data analysis.
At the end of the Method Run a Method Run Finished dialog-box will display.
During the Running stage of the Method Run, OpenLab DWM will continue to monitor Bath Temperature and RPM values. Taking Vessel temperatures at any prescribed timepoints. In addition, the Timers panel will show information such as time elapsed. Furthermore, the Test Status panel will show which timepoints have/ have not been completed. |
Click OK to close the dialog-box.
The Instrument Status will revert to Green signifying that it is in an idle state.