This check box is marked to indicate that a BCD/external contacts board has been detected during autoconfiguration. For manual configuration, mark the External contacts board installed check box to indicate that a BCD/external contacts board is installed. Specify the use of external contacts in the External Contacts.
When the External contacts board installed check box is cleared, the External Contacts section of the method setup is not present. |
This check box is marked to indicate that a thermostat has been detected during autoconfiguration. For manual configuration, mark the Thermostat installed check box to indicate that a thermostat is installed. Specify the thermostat parameters in the Fraction Collector Control dialog box.
Mark this check box to indicate that a UIB is connected, and an MSD is connected to it, to enable mass-based fraction collection.
The MSD is not detected automatically; you must mark the check box manually. |