Quaternary Pump Dashboard Panel

Module Graphic

The items in the pump graphic have the following meaning and function:

	Indicates that an External Contacts board is installed.
	When the solvent level falls below the specified volume, the yellow warning is shown; when the bottle is empty, the red error is shown. Clicking on the solvent bottle displays the Bottle Fillings dialog box. The tooltip for the bottle shows the solvent name.
	(G4204A, G7104A/C and G7131A/C) Indicates that the ISET option is installed but with no active method (gray) or installed and active (black).
	(G4204A, G7104A/C and G7131A/C) Indicates that Blend Assist is activated in the method.
	The pressure setpoints. The red line shows the current maximum pressure limit; the gray area shows the current pressure (also shown as text).

The current solvent flow rate (in mL/min) is displayed above the pressure display.

Actuals

The following pump actuals are displayed:

Flow	The current solvent flow rate (in mL/min).
Pressure	The current pump pressure (in bar or psi).
Ripple	(Not G4204A or G7104A/C) The current ripple (in %).
Tuning	(G4204A and G7104A/C) Indicates the tuning efforts of 1290 Infinity pumps. For pumps operating as expected, the signal should stay in a range of -1 to +1 within the full scale of -2 to +2.
Pressure Limit	The current maximum pressure limit.
Composition A, B, C, D	The percentage contribution of each of the solvent channels to the current solvent composition.
Mixer	The installed mixer type.
Solvent <n>	The solvent configured for each channel.
Purge Status	The current status of the pump purge. (G4204A only)
Prepare Pump	Displays the current pump preparation operation and the remaining duration for Purge or Conditioning, or the run time for Prime. (G7104A/C only)
Valve Position	The current valve position. (G4204A and G7104A/C)

Context Menu

The context menu contains the following commands:

Control	Displays the pump's Control dialog box.
Method	Displays the pump's Method Setup dialog box.
Error Method	Set Error Method Sets the error method to the method that is currently available in the hardware. The error methods are loaded automatically on all modules if an error occurs. Clear Error Method Removes the currently loaded error method.
Identify Device	Causes the LED on the front of the module to blink for a few seconds.
Switch On/Off	Toggles the status of the pump, on or off.
Bottle Fillings	Displays the Bottle Fillings dialog box.
Purge On/Off	(G4204A only) Toggles the status of the pump purge, on or off.
Prime On	(G4204A only) Turns on the pump priming function. Proming is turned off automatically.
Conditioning On/Off	(G4204A only) Toggles the status of system conditioning, on or off.
Prepare Pump	(G7104A/C and G7131A/C) Displays the Prepare Pump dialog box.
Flush Filter On/Off	(G4204A, G7104A/C and G7131A/C) Toggles the status of filter flushing, on or off.
Seal Wash Prime	(G7104A/C and G7131A/C) Allows you to ensure that all air bubbles in the seal wash lines are removed (for example, after the seal wash solvent bottle has been refilled).