During a run you may want to monitor some of the parameters in the run. Some of these parameters can change during the run.
You can monitor the following SQ parameters:
*TIC: Scan - A TIC scan over the mass range in that segment in the method.
Rough Vac - the pressure in the region between the capillary and the skimmer.
High Vac - the pressure in the region of the quadrupole and the detector.
Turbo1 Speed
Pump1 Current
MS Heater - the temperature of the Quad Mass Filter. The default temperature is 100 °C. You cannot change this temperature.
*Gas Temperature - See Gas Temperature.
*Gas Flow - See Gas Flow.
*Nebulizer - See Nebulizer.
* Capillary Voltage - See Capillary Voltage.
*Chamber Current
*Capillary Current - See Capillary Current.
*Corona Voltage -
*Vaporizer - See Vaporizer.
APPI Lamp - See Turn APPI lamp on or off .
*The parameter can change during the run.