The Level Sensing Configuration dialog box is displayed when the auto configuration has detected a Level Sensing module and you select Show Level Sensing Configuration in the Connection Settings dialog box.
The dialog box shows one tab per configured Level Sensing module (usually only one). They are numbered LS-1, LS-2, ...
The graphic on the left side shows the bottle positions of the Level Sensing module. Its type ID, serial number, and firmware revision are shown below.
To view the parameters of a bottle, click on the position in the graphic.
NOTE
To modify the configuration, select Level Sensing Assignment from the pump's Dashboard context menu.
For each position, the following parameters are displayed:
<Selected position> - Position | ||
Channel Assignment | The assigned channel or Not assigned | |
Solvent Name | The solvent name or no name | |
| ||
<Selected position> - Limits | ||
Prevent analysis if level falls below | If the check box is marked and a threshold is specified: | |
Turn pump off if running out of solvent | If the check box is marked and a threshold is specified: | |
base-id: 11630400523
id: 11630400523