Swap qualifier to target

Privileges

• OpenLab CDS: Method Development > Edit identification parameters
  Privileges are configured in the Control Panel.

Prerequisites

• If the project enforces method approval, the method status must be Generic. For details, see Method approval.

• The compound is defined on an EIC or SIM signal.

1. In the processing method, select the Compounds > Identification node (Compound Table tab).

2. Select the compound for which you want to swap target and qualifier.

3. In the Qualifier group details table to the right of the compound table: Right-click the qualifier that you want to be the target, then select Swap qualifier to target.

   If a calibration curve already exists for the modified compound, this calibration curve (including all history calibration points) is removed from the method. It will be recalculated when the result set is reprocessed.

4. Reprocess to update the results.