Review a snapshot

From Acquisition, you can open a currently running sample in Data Analysis ( in the Online Signals window). In Data Analysis, you can process and report the already acquired data.

During the review:

• The review status is indicated by a yellow bar at the top of the workspace. It informs you about the snapshot mode and the instrument where the data has been acquired.

• Data Analysis is restricted to the already acquired data. You cannot browse other project data (see Review mode).

• The result set version is labeled SNAPSHOT-xxxx xxxx xxxx xxxx to indicate that it contains a snapshot run.

• The acquisition of the current sample continues. When the acquisition has finished, the status in the Run Queue will be in Review until you close the data. For dual sequences saved as two result sets, close both result sets.

• The injection is not processed immediately. It will be processed as soon as you finish the snapshot review and close the data. For dual sequences saved as two result sets, close both result sets.

• You can reprocess the snapshot with a given processing method, edit the method, create reports, or link the injections to another method and reprocess.

• Any saved results, methods, or templates are stored in the secure storage. If you reprocess and save snapshot, it will later be available as version SNAPSHOT-xxxx xxxx xxxx xxxx.

After finishing the snapshot review and closing the data:

• If relevant, Acquisition initiates the automated processing of the injection results. These results are available as version Acq-xxxx xxxx xxxx xxxx.

• If you changed the processing method and saved it, this saved method will be used for the processing.

• If you changed a report template and saved it, the saved template will be used to report the data.

• Acquisition continues with the next items in the run queue.

After an inactivity of 30 min, Data Analysis automatically closes the data loaded in the review instance, and discards any unsaved changed.