Use this function to select the peak width (response time) for your analysis. The peak width is defined as the width of a peak, in minutes, at half the peak height. Set the peak width to the narrowest expected peak in your chromatogram. The peak width sets the optimum response time for your FLD. The peak detector ignores any peaks that are considerably narrower, or wider, than the peak width setting. The response time is the time between 10% and 90% of the output signal in response to an input step function.
This function is not available with the G1321C or G7121A FLDs. |
Peak Width (min) | Response Time (sec) |
|---|---|
<0.005 | <0.12 |
>0.005 | <0.12 |
>0.010 | <0.25 |
>0.025 | <0.5 |
>0.05 | <1 |
>0.1 | <2 |
>0.2 | <4 |
>0.4 | <8 |
The Data Rate (Hz) is defined by the initial peakwidth, and will not change during the run. |