For manual configuration of individual devices, the parameters are in up to four sections:
For manual configuration, select the Type ID from the drop-down list and enter the Serial number of the device. The Device name is displayed automatically.
The Firmware revision is a read-only value that is updated during autoconfiguration.
Shows the type of needle that is set up in the firmware of the fraction collector. If the actual installed needle differs from that shown in the Installed Needle field, use the Modify > Tubings item from the context menu of the module panel in the dashboard to change it.
Shows the tubing kit that is set up in the firmware of the fraction collector. If the actual tubing kit differs from that shown in the Tubing Kit field, use the Modify > Needle and Tubing item from the context menu of the module panel in the dashboard to change it.
This check box is marked to indicate that a thermostat has been detected during autoconfiguration. For manual configuration, mark the Thermostat Installed check box to indicate that a thermostat is installed. Specify the thermostat parameters in the Fraction Collector Control dialog box.
This check box is marked to indicate that the G7159B Preparative OpenBed Fraction Colector is configured for use as both Fraction Collector and Sampler.