Draw (Dual Loop Autosampler)

Enables the autosampler to draw from a specified Source.

Parameter	Value	Description
Draw	Default	The default amount specified in the Set Up Agilent Autosampler panel. See Set Up Dual Loop Autosampler
	Maximum	The maximum amount defined by the autosampler configuration.
	Amount	An amount that overrides the default injection volume.
from	Sample	From the position specified in the sample information or sequence/worklist.
	Location	From a specified location.The location can be a well or a vial. See Specifying a Location.
	Seat	From the seat capillary.
	Air	From air, above the seat capillary.
	Vial+	This function is for vial trays only.
	Sample+
	Plug	From plug specified in the Plug Settings
	Flushport	From wash port
	Flush	From flush solvent
Speed	Default	The default speed, specified in the Set Up Agilent Autosampler panel. See Set Up Dual Loop Autosampler
	Maximum	The maximum draw speed
	Speed	A value that overrides the default draw speed.
	Rinse	The default rinse speed, specified in Set Up Dual Loop Autosampler
useOffset	Default	The default draw position, specified in Set Up Dual Loop Autosampler
	Value	The offset of the autosampler needle is calculated from the BOTTOM of the well, with a slight amount of clearance to cover tolerances. Use a negative offset to touch the well bottom with the needle. Use a positive offset to raise the needle higher in the well to clear precipitates on the bottom of the well, or to select one phase of a biphasic sample. The units are millimeters, with 1/10 mm resolution. The range of offsets available is from -2.5 to 35.0 mm.