Each Split Mode encodes a specific combination of the Flow Modulator's groove volume and the switching frequency (in Hz) that are used when the Flow Modulator is active during a run.
Click the down-arrow and select a Split Mode from the list.
To help you select the most appropriate Split Mode for your application, the expected Split ratio and Dilution factor values are calculated based on the values you entered in Intended Pump Flow.
If the Flow Modulator is used with a UV detector in the make-up stream, use a Peakwidth equivalent to a data rate of 2.5 Hz data rate to prevent the disintegration of the peak into individual aliquots. |