Modify Recovery Settings

Active Collector

Click the down-arrow and select the fraction collector on which to start recovery collection.

This item is available only if the configuration includes more than one recovery collector.

Start Location Mode

Click the down-arrow and select the start location mode from the drop-down list:

• Use start location

  Activates the Start Location field, which allows you to specify a location on the recovery collector where you want recovery of the eluent to start. Use the syntax according to the plate naming scheme supported by your CDS.

  Use start location is valid only for the next run.

• Next Position

  Recovery starts at the next available position on the current module.

When Recovery out of Locations

Use this section to specify what happens when there are no more locations available on the recovery collector.

Stop Analysis with Error	Stops the analysis and generates an error.
Switch to Waste	Switches the eluent between fractions to waste; the eluent that is not collected as a fraction is diverted to waste.