Agilent ships a set of default report templates with OpenLab CDS. These default templates provide similar content as the earlier classic reports but now in smaller, focused reports rather than one big report. When creating new templates, you may start from one of these default templates.
After importing the default templates, you find the following default templates in your Report templates folder:
Single injection
Chromatography reports:
Calibration.rdl
ExtendedPerformance.rdl
ISTDWithGroups.rdl
NormAmount.rdl
Performance+Noise.rdl
Purity_Flow.rdl
Qualitative_Long.rdl
Qualitative_nBiggestPeaks.rdl
Qualitative_Short.rdl
Short_Area.rdl
Short_Estd.rdl
Short_Istd.rdl
Short_Quant_Estd.rdl
Short_Quant_Istd.rdl
Method report:
Acquisition_Method_Report.rdl
Method.rdl
GCMS Reports
GCMS_Unknown_Analysis.rdl
GCMS_Unknown_Analysis_Long.rdl
LCMS Reports
LCMS_SamplePurity_Long.rdl
LCMS_SamplePurity_Short.rdl
Preparative_LC_W_MS_Spectra.rdl
MS reports:
MS_Deconvolution_Short.rdl
MS_LibrarySearch.rdl
MS_LibrarySearch_CrossPeak.rdl
MS_LibrarySearch_Long.rdl
MS_LibrarySearch_Short.rdl
MS_Purity_Separated.rdl
MS_Qualitative_One_Page.rdl
MS_Quantitative_Long.rdl
MS_Quantitative_Short.rdl
MS_SamplePurity.rdl
MS_Spectra_Purity.rdl
MS_Spectra_Purity_Long.rdl
Single sequence summary
Audit_Trails_Report.rdl
SequenceSummary_Extended.rdl
SequenceSummary_Short.rdl
Cross sequence summary
Stability_Report.rdl