In the Method Properties, select the Setpoint page.
Select only one of the levels.
Save the settings.
Generate the report.
Check whether the required section is included in the report. If it is not, repeat the procedure with the next level.
If you clear the higher levels and select only one of the lower levels, for example only level 5, the report still includes the section names contained in the higher levels. The detail information is shown only for the selected level. If you want to hide the section as well, create a filter for the required sections. |
If you want to show only a specific section, you can create a filter for the section name as described in the following procedure. This will remove all sections, including their sub sections, that do no match the filter expression.
In the Method Properties, select the Filter page.
Under the level that you identified above, create a filter expression for the required section. The filter expression is always SECTION NAME.
For example: SECTION NAME=Signals
Save the settings.