Edit the Ramp Table (LC/MS)

The columns available in the Ramp pop-up window are Mass (m/z) and Fragmentor voltage (V).

  1. If necessary, show the Aquisition Parameters table.

    1. Click Method.

      Ribbon_MethodLayout.jpg
    2. In the Acquisition Method window in the navigation pane, click Instrument Setup > SQ.

    3. In the navigation pane, select Advanced Acquire > Acquisition.

  2. Edit the Acquisition Parameters Table.

  3. Select Fragmentor ramp? in the Acquisition Parameters table. The value in the Fragmentor (V) column changes to Ramp.

  4. Click > in the Fragmentor ramp? column.

  5. In the Acquisition > Ramp Table section, review the values for the fragmentor ramp. To make a change, do the following:

    1. Click a value in the Mass (m/z) column.

    2. Enter a mass.

    3. Click a value in the Fragmentor voltage (V) column.

    4. Modify the fragmentor voltage.

    5. To add a row at the end of the table, click TB_AddRowScanSegments.jpg. A new row is added at the end of the table. It has the same values as the row that was selected.

    6. To delete a row, first highlight the row, and then click TB_DeleteRowScanSegments.jpg.

  6. Click anywhere out of the pop-up window to close the pop-up window.

See Also

Edit a method

Acquisition > Ramp Table