Moves to a specified position and ejects a specified amount from the needle.
Parameter | Value | Description |
|---|---|---|
Eject | Default | The default amount specified in the Set Up Agilent Autosampler panel. |
| Maximum | The maximum amount defined by the injector configuration. |
| Amount | A specified amount that overrides the default amount. |
to | Sample | The position specified in the sample information or sequence/worklist. |
| Location | From a specified location. The location can be a well or a vial. |
| Sample+ | Sample+ is used for wellplate sample locations only; it defines an offset from the current location. You specify the offsets for Tray, Plate, Row and Column individually. For example, if the current location is P1-A-01, values for Plate, Row and Column of 1 define location P(1+1)-(A+1)-(01+1), which is P2-B-02. The limits are: Tray: -1 to +1 (only valid if two trays are inserted) Plate: -2 to +2 (only valid for wellplates) Row: -15 to +15 Column: -23 to +23 |
| Vial+ | This function is valid for vial trays only. Vial+ is used for sample vial locations only; it defines an offset from the current sample vial number. For example, if the current sample vial is 1, a value for Vial+ of 3 specifies a vial that is three positions away from the sample vial, in this case vial 4. The limits are independent of the sample tray configuration: -99 to +99 |
| Waste | The waste vial. |
| Flushport | The flush solvent. |
| Seat | The seat capillary. |
Speed | Default | The default eject speed specified in the Set Up Agilent Autosampler panel. See Set Up Dual Loop Autosampler
|
| Maximum | The maximum eject speed. |
| Speed | A value that overrides the default eject speed. |
| Rinse | The default rinse speed, specified in Set Up Dual Loop Autosampler |
useOffset | Default | The default offset position, specified in the Set Up Agilent Autosampler panel. |
| Amount | -2.5 to +35 mm below or above the normal offset position |
base-id: 3268741643
id: 3268741643