Method > Timetable (LC/MS)
You can change the position of the diverter during a run. You can specify to send the stream from the LC to either Waste or MS. If you divert the stream to Waste, then you do not acquire data at that time.
What do you want to do?
User Interface - MS Global Parameters Pane
Each section in the SQ section of the Method Editor has two panes. The MS Global Parameters pane is the top pane in the Instrument Setup > SQ > Method section. It is visible when any of the Instrument Setup > SQ > Method sections are visible. See Advanced Acquire > MS Global Parameters Pane (LC/MS).
User Interface - Timetable
The following columns are available in the Timetable.
- Start Time (min) - The time to switch the diverter either to MS or to Waste.
- Type - Diverter
- Value - Either To MS or To waste.
Post-run diverter position
To MS or To waste. At the end of a run, you may want to divert the LC stream from the instrument.
User Interface - Toolbar
This toolbar allows you to add and remove rows from the Chromatograms table.
| Toolbar icon | Action |
 |
Add a row to the table |
 |
Remove the selected row from the table |
See Also
Method > MS Global Parameters Pane (LC/MS)
Method > Acquisition Section (LC/MS)