This task assumes that the PAL Sampler add-on software has been installed and the PAL Sampler hardware system has been configured. For information about configuring the PAL Sampler, refer to the PAL Sampler user information provided with the instrument.
To configure the PAL Sampler with your data system:
Open the data system's instrument configuration utility.
Select and open the desired instrument.
Enter the PAL sampler configuration information:
Enter the desired Instrument Name. See Connection for more information.
Enter the IP Address or Host Name.
If desired, add any Device ID and Notes.
Click Load Configuration. The software communicates with the PAL Sampler. When the software receives configuration data from the PAL Sampler, a confirmation message displays below the button, and the Serial Number and Firmware Version populate.
If the configuration includes a barcode reader and its objects are included in the control module, you can change the default location for the barcode reader vial (if desired). See Connection for more information.
Open a data system online session for the instrument.
Set the data system's injection source to your Pal3 sampler. See Select Injection Source.
Configuration with your data system is complete.