These messages apply to the LC/MSD Pro iQ and Pro iQ Plus Single Quadrupole instrument. To see error message for the LC/MSD iQ Single Quadrupole instrument, see Error Messages (LC/MSD iQ).
AJS Sheath Gas Flow fault - the Zone controller cannot regulate for the requested setting (LC/MS)
Ambient temperature is out of operational limits on the Interconnect Board (LC/MS)
APCI fault - Output voltage is not within operational limits (LC/MS)
Drying Gas Flow fault - The Zone controller cannot regulate for the requested setting (LC/MS)
Drying Gas Heater shutoff due to temperature exceeding maximum limit (LC/MS)
Drying Gas Heater Temp Sensor reading is out of operational limits (LC/MS)
Foreline pressure above 5 Torr after reaching 4.4 Torr during pump down sequence (LC/MS)
Foreline pressure failed to reach below 4.4 Torr during pump down sequence (LC/MS)
High Vacuum Pressure failed to reach 1.0e-4 Torr during pump down sequence (LC/MS)
Loss of communication with LC stack after successful communication established
Nebulizer Pressure fault - the Zone controller cannot regulate for the requested setting (LC/MS)
Nozzle HV Fault - Output voltage is not within operational limits (LC/MS)
Rough Pump reporting internal fault or loss of communication (LC/MS)
Source Heater Temperature Sensor reading is out of operational limits (LC/MS)
Turbo Pump reporting internal fault or loss of communication (LC/MS)
VCap/VCham Fault - Output voltage is not within operational limits (LC/MS)